RUBBER DUST BOOT - SUIT 3/4" ROD ENDS

You are purchasing- 
1 x RODBOOT-12 To suit 3/4" Rod Ends.





DIMENSIONS- 
SHANK HOLE DIA- SUITS 3/4" THREAD
THROUGH HOLE DIA- SUITS 5/8" OR 1/2" BOLT OR MISALIGNMENT SPACER

DUST BOOT MATERIAL- RUBBER


A Rod End Dust Boot is a protective cover designed to shield rod ends (also known as Heim joints or spherical bearings) from dirt, dust, and other contaminants. 
These boots are made of rubber & help extend the lifespan of the rod ends by keeping grease in and debris out.
They're especially useful in automotive and industrial applications where components are exposed to harsh environments.

Uses in Automotive and Racing

1. Suspension Systems: Dust boots protect rod ends in suspension setups, such as control arms and sway bars, ensuring smooth articulation and reducing wear.

2. Steering Components: They safeguard tie rod ends and other steering linkages, maintaining precise handling and responsiveness.

3. Drivetrain Applications: In racing, where components are exposed to extreme conditions, dust boots help protect rod ends in drivetrain assemblies, ensuring reliability.

4. Off-Road and Rally Cars: These vehicles face harsh environments with mud, water, and debris. Dust boots keep contaminants out, extending the life of rod ends.

Benefits

• Enhanced Longevity: By keeping dirt, moisture, and debris out, dust boots prevent premature wear and corrosion of rod ends.

• Improved Performance: Clean and well-lubricated rod ends ensure consistent performance, which is crucial in high-stakes racing.

• Cost-Effectiveness: Protecting rod ends reduces the need for frequent replacements, saving money in the long run.

• Versatility: Dust boots are available in various sizes and materials, making them suitable for a wide range of applications, from daily drivers to high-performance race cars.

These boots can be quite tricky to install, if you would like us to pre-install them onto your Heims please leave a note during checkout (Heims must be purchased in same order)
Alternatively, if you plan on fitting them regularly you can purchase an installation tool- HERE



Our Rod End Dust Boots are not only manufactured to the highest of quality control standards but are designed and engineered to an extreme duty construction, specific to the requirements of Australian Drag, Drift & Circuit Racers as well as Off-Road Race classes.



Disclaimer: This product is intended for use exclusively in race and off-road applications. It is not approved for use on public roads or highways. Any installation or use of this product on a road-registered vehicle must be reviewed and approved by the purchaser's preferred engineer to ensure compliance with all applicable regulations and standards. The seller is not liable for any misuse of this product or failure to adhere to these conditions.